Python3 scratchnsniff.py -dstip 10.0.1.252 -packetfilter 'port 5060' -interface enp0s25Ĭapture all sctp and icmp traffic on interface lo and send it to 10.98.1.2: Example UsageĬapture all traffic on port 5060 on interface enp0s25 and send it to 10.0.1.252 There's a good chance that you'll also see a lot of icmp errors, so suggest using the filter 'tzsp and not icmp' in Wireshark. On the remote machine, start Wireshark, and filter by 'tzsp' and you'll see all the remote traffic being mirrored. You can stop the capture with Control + C to exit. The dstport (Destination Port) to send the TZSP encapsulated traffic to on the remote host (defaults to 37008.) If this is not set then all traffic on the interface is captured. The packetfilter which is the TCPDump Filter formatted filter to be applied to incoming traffic, that if matched, will see it forwarded. The dstip (Destination IP) to send the matching packets to, this is the remote machine you're running Wireshark or similar on. Usage of all interfaces (aka 'any') is not currently supported. The interface to capture on (ie wlan0, eth0, enp0s25, etc) - This is the interface we will capture the traffic from. It captures packets matching the defined packet filters (standard TCPDump filters), then encapsulates the data into TZSP and forwards / mirrors it to a remote host, which can then view the data live with Wireshark. Scratch'n'Sniff is a very simple remote packet sniffer, that aims to avoid the start tcpdump, capture required info, transfer with SFTP, view in Wireshark, grind. There is code.Scrach'n'Sniff - Simple Remote Packet Sniffer / Mirror What it Does Hint 2: There is no simple way to generate a radiotap header from the values of the TZSP header, so you'll probably loose that information!īittwiste is part of the Bit-Twist tool package The resulting file will only contain IEEE 802.11 frames, actually anything that was encapsulated in TZSP. If you are able to post a small pcap file with TZSP somewhere (google drive, dropbox, ), I'll check it. Hint 1: I'm not sure about the range 0-4F. You can strip the unwanted headers (ethernet up to UDP) with bittwiste.īittwiste -I tzsp.pcap -O tzsp-stripped.pcap -D 0-4F
Is there anyway to convert TZSP to something that Aircrack can use it.
0 kommentar(er)
